The Curt Class III hitch # C13315 made for your 2016 Lexus NX 200t does indeed use a different mounting point than the Draw-Tite # 75956. The reason is that the higher tongue weight (TW) capacity of the Curt hitch, 600-lbs, requires installation on a different section of the frame. My contact at Curt confirmed this for me. The other hitches' TW capacities are 350-lbs. I'd definitely go for the Curt hitch for your car.
All hitches fit your car, install without drilling and come with the... view full answer...
For the 2016 Lexus NX 200t F-Sport both of the aftermarket 4-pole wiring harness kits we offer, Curt # C56268 and Tekonsha # 118652, use a separate 12V power wire that will be run to the battery and connect through an included fuse holder. This separate power connection delivers the actual current to operate trailer lights, bypassing the vehicles internal wiring. This isolates the car's wiring from any potential damage from short-circuits on the trailer.
Apart from this one power wire... view full answer...
When you install an aftermarket part on your vehicle like a trailer hitch in this case, you are protected by the Magnuson–Moss Warranty Act. This act states, in part, that unless the installation and the part caused a problem then the warranty cannot be voided. I recommend looking it up online.
I attached an install video for this hitch for you to check out as well. view full answer...
The T-One Vehicle Wiring Harness part # 118652 is a confirmed fit for your 2016 Lexus NX 200t. This harness actually installs inline with the factory taillight wiring harness so there will not be any sort of unused plug if that was what you were looking for. In order to access the factory taillight wiring harness you need to remove a few trim panels. I have then attached a photo that shows where the factory taillight wiring harness is located.
Unfortunately, we have not yet had the chance... view full answer...
Go To Results